Tc-electronic Nova System Manual do Utilizador descarregar pdf (Página 30)

EFFECTS - EQ & NOISE GATE

Mode

Range. Hard or Soft

General overall mode that determines how fast the Noise

Gate should attenuate/dampen the signal when below

Threshold.

Threshold

Range: -60 dB to 0 dB

The threshold point determines at what point the Noise

Gate should start attenuating the signal.

To set this parameter; set the Damp parameter to e.g. 50

dB. Then start turning up the Threshold value from -60

dB to the point where desired dampening is actually

achieved. This little experiment will of course require that

the Damp parameter is set different from 0 dB - as 0 dB

means: no damping.

Damp

Range: 0 dB to 90 dB

This parameter determines how hard the signal should

be attenuated when below the set Threshold. You could

argue that a max dampening would be appropriate

always, but you would also like to have a smooth

transition between the “gated/attenuated” stage and the

“open” stage. The more dB that must be released the

more obvious the Noise Gate might seam.

Release

Range: 0 dB/sec to 200 dB/sec

The Release parameter determines how fast the signal is

released when the Input signal rises above the Threshold

point. As a rule of thumb this setting should be set fairly

high.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 45 46

Sem comentários

Tc-electronic Nova System Manual do Utilizador Página 30