Tc-electronic Manuals Manual do Utilizador descarregar pdf (Página 13)

Changing battery – Unscrew the thumb-screw on the back of the pedal and detach the back-plate.

Unmount the old battery and attach the new battery to the battery clip making sure the polarity is

correct.Thenremounttheback-plate.Tosavebatterylife,removetheinputjackwhenyoudon’tplay.

Batteries must never be heated, taken apart or thrown into fire or water. Only rechargeable

batteries can be recharged. Remove the battery when the pedal is not being used for a longer

period of time. Dispose batteries according to local laws and regulations.

will most likely be to activate the buffer in the first and last pedal in the signal chain. Can you hear the

differencebetweenapedalinTrueBypassorBufferedBypass?Maybe,maybenot,–manyfactors

apply; active/passive pick-ups, single coil/humbucker, cable quality, amp impedance and more. We

cannotgiveasingleultimateanswer.Useyourearsandfindthebestsolutionforyoursetup!

Kill-Dry on/off – With Buffered Bypass activated (upper switch to the right), the lower dip-switch sets

Kill-Dry on/off. Kill-Dry removes all direct signal from the pedals output and is the mode to use when

the pedal is placed in a parallel effects loop.

Kill-DryisNOTanoptioninTrueBypassmode.

1 2 ... 8 9 10 11 12 13 14 15

Sem comentários

Tc-electronic Manuals Manual do Utilizador Página 13